shop-talk
[Top] [All Lists]

Re: [Shop-talk] VFDs

To: Shop Talk List <shop-talk@autox.team.net>
Subject: Re: [Shop-talk] VFDs
From: "David C." <cavanadd@verizon.net>
Date: Sat, 06 Jun 2009 13:29:39 -0700
One other thing I forgot to mention.  My motor is 3 phase, 208 volt. 
Most of the VFDs are rated for 230 volts.  If I drive the motor with a 
slightly higher voltage, the amp draw should be slightly less, but is it 
going to mess up the motor (or vfd)?

Thanks again.



David C. wrote:
> e.  Also, the existing saw has an Allen Bradley push button starter
> mounted on the front of the saw.  With a VFD I can get rid of the
> starter and use low voltage switching via the VFDs inputs to start and
> stop the saw.  If I go with a rotary or static converter, or a big
> single phase motor ($$$), then I will be messing around with sizing the
> overload heaters, getting the correct coil voltages, and so on.  In my
> experience with 3 phase motor starters, this can get expensive in a
> hurry, expecially for obsolete AB stuff.
>
> Anyone got any experience with these thing or would otherwise like to
> wade in?
>
> thanks
> Dave C
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


Shop-talk mailing list

http://autox.team.net/mailman/listinfo/shop-talk

http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>