shop-talk
[Top] [All Lists]

Re: Shop heater

To: "David C." <cavanadd@verizon.net>
Subject: Re: Shop heater
From: Pat Horne <pjhorne@mail.utexas.edu>
Date: Mon, 12 Dec 2005 09:07:28 -0600
Dave,

Since you already have propane for the house, if the house propane tank 
is not too far from the shop, and the house tank is big enough, you 
could run a copper line from the tank (or house) to the shop and run 
both buildings off of one tank. We have just that setup here in Texas. 
The copper is 5/8", and we have a 2 stage regulator system, one 
regulator at the tank, and a another regulator at each building. to drop 
the pressure to what is needed. If you have to buy new regulators they 
should run about $50 each.

Some installations have only a single regulator at the tank, but that 
would require a larger gas line than 5/8" to not have a pressure drop 
when you are heating the shop and the house is using gas also.

Our house has gas water heater, cook top and furnace. The shop has a 
central heat/cool system, and the apartment on top of the shop also has 
a heat/cool, plus stove and water heater.

We run out of a 250 gal. tank and require about 3 fill ups a year. If 
you can run for longer than several months on the house tank you 
shouldn't have a problem getting at least a month of usage with both the 
house and shop running.

Peace,
Pat

David C. wrote:

>
> I'm getting ready to order a Mr Heater Big Max 75,000 BTU heater for 
> my shop.  The shop is a 24 x 48' pole building, with partially (badly) 
> insulated walls and some insulation in between the rafters and the 
> metal roof.  I only plan to heat it when I'm actually working out 
> there.  Right now I use a 40,000 BTU propane torpedo heater run off a 
> 20# tank, which works ok to get the chill off, but it won't raise the 
> inside temperature much above 45 degrees when it's in the low 30s 
> outside.  It's also noisy as hell.
>
> Does anyone have one of these heaters, or a similar one like a Modine 
> Hot Dawg, Modine PD, etc?  I'm mostly concerned about noise and 
> safety, and I would prefer one without a standing pilot light as I 
> only plan to operate the heater when I'm in the shop, mostly on 
> weekends.  Any gotchas on mounting or plumbing?   I plan to use a 
> horizontal vent through the wall, and I may not even run a thermostat, 
> just an on-off switch.  Also, how big a tank should I buy?  I know the 
> 20# tanks are way too small, and I suspect a 30 would be, too.  Since 
> we heat our house with propane, should I just get a 100 gallon or so 
> tank and have the propane delivery guy keep it full?
>
> thanks
> Dave C
>

-- 
-- Support Habitat for Humanity - a hand UP, not a hand OUT --




<Prev in Thread] Current Thread [Next in Thread>