shop-talk
[Top] [All Lists]

Re: Septic tank repair

To: "Wayne" <w.farrington@verizon.net>
Subject: Re: Septic tank repair
From: David Scheidt <dmschei@attglobal.net>
Date: Fri, 24 Jan 2003 02:58:46 -0500
>What I'd like to do is leave the concrete plug in place when I slop the repair
>concrete around the broken area. This will allow me to properly shape the part
>of the tapered hole that has broken out. The problem of course is that the
>repair concrete will most likely seal in the plug where it comes in contact
>with it. What can I put on the edge of this plug that will allow me to form
>the concrete properly but will not allow the new concrete to bond with the
>plug? Maybe some axle bearing grease or something? I suppose I could make a

There are concrete mold release agents.  I suspect there's one that 
is suitable for use on concrete.

David

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/shop-talk


<Prev in Thread] Current Thread [Next in Thread>