shop-talk
[Top] [All Lists]

Re: conversion from 3-phase

To: <shop-talk@autox.team.net>
Subject: Re: conversion from 3-phase
From: "Stan Fickes" <fickes@acm.org>
Date: Mon, 15 Jan 2001 20:41:30 -0500
I don't think I'll be wanting to reverse the lathe...! I hadn't thought of
driving the contactor coil with a transformer and using the existing
contacts. That's a good idea.

I keep thinking I should get a switch, like used for table saws and drill
presses. I wouldn't think 3/4 HP should be an excessive load, but then I'm
not a power engineer.
Stan

----- Original Message -----
From: "Randall Young" <ryoung@NAVCOMTECH.COM>
To: <shop-talk@autox.team.net>
Sent: Monday, January 15, 2001 8:23 PM
Subject: RE: conversion from 3-phase


>
> Stan :
>
> Might be cheaper/easier to find a small 110-220 autotransformer to power
the
> contactor coil.  They are commonly sold to people trying to run US
> appliances overseas and vice-versa.  A small isolation transformer, like
> those used when troubleshooting 'live chassis' televisions, would also
work
> (properly wired).
>
> Don't forget to consider how you are going to reverse your new motor.
Most
> single-phase motors will not reverse under load ...
>
> Randall

///
///  shop-talk@autox.team.net mailing list
///


<Prev in Thread] Current Thread [Next in Thread>