oletrucks
[Top] [All Lists]

RE: [oletrucks] GMC V8 pistons

To: "Bob Fischer" <r.fischerjr@worldnet.att.net>,
Subject: RE: [oletrucks] GMC V8 pistons
From: "Hanlon, Bill (ISS Houston)" <Bill.Hanlon@hp.com>
Date: Fri, 22 Nov 2002 12:46:20 -0600
Bob:    I had mentioned Egge and Terrill Machine in Texas to him.  I've done 
business with both and have been very satisfied.

-----Original Message-----
From: Bob Fischer [mailto:r.fischerjr@worldnet.att.net]
Sent: Friday, November 22, 2002 12:33 PM
To: Hanlon, Bill (ISS Houston); Joe Garcia; Old Trucks List
Subject: RE: [oletrucks] GMC V8 pistons


Give Egge Machine in Los Angeles a try. They seem to have parts for almost 
anything, but they do come via a premium price sometimes.

>I had already suggested Kanter's to him, but he said that Kanter's told 
>him the pistons were the same for the GMC and Pontiac 347.  At that point 
>he asked if the pistons for the Pontiac were the high (10.25:1) or low 
>(8.5:1) compression ratio and Kanter's replied that they were flat top.
>
>I believe that the GMC (and probably the low compression Pontiac) pistons 
>were dished to get the lower compression.  I know that the 7.6:1 
>compression ratio GMC V8 and the 10.25:1 Pontiac used the same head 
>casting, so they must have dished the pistons to reduce the ratio.
>
>Any comment Rick?
>
>-----Original Message-----
>From: Joe Garcia [mailto:chevy1@jps.net]
>Sent: Friday, November 22, 2002 9:14 AM
>To: Hanlon, Bill (ISS Houston); Old Trucks List
>Subject: Re: [oletrucks] GMC V8 pistons
>
>
>www.kanter.com/  shows everything to build the 347
>
>Joe
>----- Original Message -----
>From: "Hanlon, Bill (ISS Houston)" <Bill.Hanlon@hp.com>
>To: "Old Trucks List" <oletrucks@autox.team.net>
>Sent: Friday, November 22, 2002 5:52 AM
>Subject: [oletrucks] GMC V8 pistons
>
>
> > Anyone know where one can buy pistons for a 57 GMC 347" V8?  Or even a
> > 57 Pontiac 347" V8?
> > If Pontiac, they would need to be the low compression (8.5:1) pistons,
> > not the high compression (10.25:1) pistons.
> >
> > Stock piston (including pin and keepers) is GM part # 2371412.  Of
> > course this was 1957 only because 347 V8 was only 1957.  Picture in the
> > shop manual shows them dished.
> >
> > A guy on a old Pontiac discussion group wants to know.  I sent him
> > sign-up instructions to this list.
> > oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
>oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

"Nothin lasts forever except old Fords and a natural stone" - Willie Nelson

  http://Bobsplayce.home.att.net   e-mail -->r.fischerjr@att.net  
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>