On to my next new adventure. I am going to have a go at learning how to
weld. I plan on doing most of this learning on a trial and error basis and
I intend to read a lot and maybe view videos as a learning
tool. Unfortunately I have not been able to find a local school that
teaches this other than as a full blown class of which I don't want to go
nine months every day to school. Although it probably wouldn't hurt me. :>)
My intent is to use this primarily (at least in the beginning) for truck
and car panel repair, patching, etc. I do have a couple of old donor cars
that are ready for the scrap heap and I thought I would practice on them at
first.
Now for the question. What type of welding should I start with - mig, tig,
arc, ???.
After that is determined, I will work on equipment.
Thanks again for all your help.
Jim V.
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|