Guys,
I've been wire-brushing my cab on my '50 1/2ton deluxe to prepare it for
painting and have reached the point where I want to get the original rubber
molding out from around the windshield. Some of the rubber is cracked and
all of it is hard as a rock. What is the best way to soften/remove it
without destroying the stainless molding? I don't need the glass because I
already got new glass cut to replace the old, but I bought this truck only
because it had a complete set of stainless trim around the windshield, so
I'm looking for non-destructive methods.
Thanks in ADvance,
Tim '50 Chev 1/2t dlxs
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|