Simon,
As I am building my own harness (a la Dan Master's article in the British
V8 Newsletter) I have plenty of wire. But I have found a flaw. I thought
the wire would run up inside the A post - but it will not. The post has no
"through hole" at the top and I cannot drill it out. Going on the outside
is possible but not good. Jim Stuart says he routed his on the floor next
to the sill passenger side and that is what I will do - stick it down with
duct tape or hot glue as Jim does.
At 11:47 AM 8/3/02 -0700, you wrote:
>Sounds like a great idea, Barrie. I'm curious as to how you are going to
>extend the harness to cover the extra distance. Are you planning on just
>making up an extra harness to go between the main one and the rear sub-harness?
>
>Simon
>
>
>
>>I have been in correspondence with a lister re wiring - but I have deleted
>>the email so I have no contact address. But here is the information I
>>wanted to impart. I am going to route the wire for the rear lights etc
>>over the door (GT) and down - This means the wire will not go on the
>>outside of the car. The usual routing under the chassis was probably done
>>for cost rather than for suitability. This way my wiring will not be
>>endangered by stones and the teeth of road kills, etc.
>>
>>
>>
>>Regards
>>Barrie
>>
>>Barrie Robinson - barrier@bconnex.net
>
>
>_________________________________________________________________
>Join the world's largest e-mail service with MSN Hotmail.
>http://www.hotmail.com
>
>
Regards
Barrie
Barrie Robinson - barrier@bconnex.net
///
/// mgb-v8@autox.team.net mailing list
/// Send admin requests to majordomo@autox.team.net
/// Send list postings to mgb-v8@autox.team.net
/// Edit your replies! If they include this trailer, they will NOT be sent.
///
|