mg-t
[Top] [All Lists]

Re: [mg-tabc] Water temp sensor location

To: Chip Old <fold@bcpl.net>, mgt <mg-t@autox.team.net>,
Subject: Re: [mg-tabc] Water temp sensor location
From: Skip Kelsey <kelsey@shadetreemotors.com>
Date: Thu, 27 Mar 2003 20:04:06 -0800
Chip:

I have my temp also taken off of the rear plate.I then temporarily 
installed one in the header tank, and drove around with this dual gauge 
setup for a while. I only notice about one degree of temp difference. I 
opted for the rear mount as being more reliable.

Cheers;

Skip Kelsey..............................................


At 06:48 PM 3/27/03 -0500, Chip Old wrote:
>True, but if the coolant level drops that low then you have other problems
>that need to be addressed.  The header tank location will give you a more
>accurate reading of coolant temperature than your rear plate location, but
>not as accurate as a sensor located in the water outlet elbow between the
>head and thermostat.

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/mg-t


<Prev in Thread] Current Thread [Next in Thread>