I have a new PA crankshaft - ex Belgium I think. The front main
journal should be 1.625". but it is in fact 1.75" anyone got advice how
to handle this? I don't think there's enough meat to just open things
out and I'm reluctant to machine the shaft.
Viv (slightly confused as usual)
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|