In a message dated 10/8/02 06:23:53 Pacific Daylight Time, DENKLEMM@aol.com
writes:
<< I am missing the roller bearing for the handbrake cross-shaft. I have been
told that it is not available. Anyone have a spare or a solution?
Thanks for the help
Dennis Klemm
PA1518 >>
Dennis, you can make a new one out of piano wire but the better solution is
to turn up a bronze bushing to replace it. If yours is anything like mine
was, it will be very corroded in there......This was not a caged bearing but
just a lot of loose pieces.
Terry
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/cgi-bin/majorcool
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-mmm
/// Send list postings to mg-mmm@autox.team.net
|