My valve stems are perpendicular to the rim (straight up or otherwise)and my
caps are sealed with an o-ring inside. I don't believe the inner stem will
release air at speed with the aluminum cap and o-ring. They have not so far.
As I mentioned, the bike is designed to run at speed from the showroom. It
is raced at 165 mph down straight a ways on tracks over and over without any
problems. I just want to make sure I have complied with all the rules so I
don't spend lots of dollars and time and then get out to the flats only to
discover I cannot run because something was overlooked.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|