Minilites?
How old?
I bought a set and had to have the cone surfaces re machined.
Clean the cone surfaces and apply engineering blue.
Knock the wheels on and drive gently around the block.
Come home and look at the blue.
Jags etc had a different taper angle.
I suspect that is your issue.
It something like â??should be 8 degrees, but itâ??s 9.5â??
But I donâ??t remember.
The angle required is in your spinner on the outside, and on your hub on the
inside.
I suspect the angles on your wheel donâ??t match
> On 9 May 2024, at 11:09â?¯AM, pieter scheenhouwer via Healeys
> <healeys@autox.team.net> wrote:
>
> Gents,
> I have 2 sets of wheels for my BJ7. A set of wires and a set of minilite
> replicas.
> Recently, I am having trouble getting the front wheels tight enough. It seems
> the thread on the hub is bottoming out in the spinner before it clamps the
> wheel properly unless I belt the hell out of it to get it tight enough.
> The hubs and spinners have been on the car for over a decade. Car is a daily
> driver.
> The obvious fix is to file/machine the end of the hub or replace the spinners.
> Anyone else have this issue before.
> Cheers
> Piet
> Sent from my iPhone
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
>
> Archive: http://www.team.net/pipermail/healeys
> http://autox.team.net/archive/healeys
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/austin.healey@gmail.com
>
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/pipermail/healeys
http://autox.team.net/archive/healeys
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/mharc@autox.team.net
|