Further to my post of a few days ago about low oil pressure I pulled the
bottom end apart and will be replacing rod and main bearings. I removed
the oil release valve cap nut and spring but cannot get the valve
itself--the plunger--out. I had a small magnet probe that seemed to go all
the way into the plunger's recess but it would not extract the part.
Is there some trick here? I had it out a number of years ago and do not
remember encountering any problem. I could probably pass a tap into it
from the side and engage the inside of the plunger so I could extract it
but there must be some better way. Suggestions/experience appreciated.
Best--Michael Oritt
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170929/f75bea4e/attachment.html>
|