healeys
[Top] [All Lists]

Re: [Healeys] Dash mount studs or bolts BJ8

To: "Weston Keyes" <westonkeyes@hotmail.com>, "Ahealey Ahealey"
Subject: Re: [Healeys] Dash mount studs or bolts BJ8
From: "Rich C" <richchrysler@quickclic.net>
Date: Sat, 28 Feb 2009 19:14:32 -0500
Wes,

There are four mounting holes that line up the base of the windshield 
stanchions to the body in this location. One of these bolt holes (second one 
down) should also line up the oval hole in the dash mounting bracket. There 
are usually aluminum shims that need to pack between these stanchions and 
the body to adjust the fit of the windscreen assembly to the body. These 
also have the 1/4" bolts passing through these shims. The heads of the bolts 
should be on the inside of the car with the flats, lockwashers and nuts 
sitting outboard as shown in the accompanying picture. There is relief in 
the under side of the quarter trim panels to allow for the thickness of the 
bolt heads.

Rich Chrysler

----- Original Message ----- 
From: "Weston Keyes" <westonkeyes@hotmail.com>
To: "Ahealey Ahealey" <healeys@autox.team.net>
Sent: Friday, February 27, 2009 8:18 AM
Subject: [Healeys] Dash mount studs or bolts BJ8


> Hello Folks,
>
>     I am restoring a car I didn't take apart. There was body work done 
> around
> where the dash ends mount to the body and also the windshield is attached.
> There are 2 cast aluminum brackets that are screwed into the dash and 
> attach
> to the body. Was there originally a stud welded to the body that goes 
> through
> the hole in the casting? I just have a hole now. If they used a bolt the 
> head
> would be covered up by the mounting plate of the windshield. Any clues?
>
>   Thanks for your patience.
>
> Wes Keyes
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as richchrysler@quickclic.net
>
> http://www.team.net/archive

[demime 1.01d removed an attachment of type image/jpeg which had a name of Dec 
06 001.jpg]

[demime 1.01d removed an attachment of type image/jpeg which had a name of 
Convertible Detail 0002.jpg]
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>