In a message dated 2/3/2009 8:56:55 P.M. Eastern Standard Time,
fortee9er@yahoo.com writes:
The top bolt no problem but the bottom bolt not so good there is very little
room for the nut to fit between the starter motor and and the mounting tab.
I should clarify that the nut will just fit but not the nut and the lock
washer. I am thinking of finding a thinner nut that will fit with the lock
washer. Any ideas suggestions would be greatly apprciated
----------------------------------------
Jorge--
Though I used a thin nut and lock washer when mounting the gear starters on
the Healeys on the Elva (MGA engine) I went a different route and had a new
nose piece machined out of aluminum with threads in the bottom tab which
eliminated the need for the nut. You might get away with a helicoil.
Best--Michael Oritt
**************Great Deals on Dell Laptops. Starting at $499.
(http://pr.atwola.com/promoclk/100000075x1217883258x1201191827/aol?redir=http://ad.doubleclick.
net/clk;211531132;33070124;e)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|