Hi,
I would say way too much protrusion. I normally have <0.0027.
If the block has been decked the liner seat has to be recessed too and maybe
even the piston decks need some attention to maintain the proper clearance to
the head.
Cheers
Chris
-----Original Message-----
From: Fot <fot-bounces@autox.team.net> On Behalf Of Philip Gott via Fot
Sent: Sunday, May 14, 2023 7:39 PM
To: Friends Of Triumph <fot@autox.team.net>
Subject: [Fot] TR sleeve protrusion .011
Has anyone had experience with the cylinder sleeves protruding .011â??? The
head has been staked per Kasâ??s book.
I am trying to build an engine quickly (avoiding machine shop delays) and have
a block with billet crank and Chris Marx seal installed. It has been decked
already. Also line bored and cam bearings and cam installed and timed. I want
to know if I can assemble this with confidence or if I am asking for trouble?
I donâ??t anticipate problems with oil or water sealing as I will use Hylomar
on a .020â?? steel head gasket with the raised corrugating around the oil and
water galleys.
The crank broke and a cylinder sleeve cracked in â??old reliableâ?? during a
test day.
Please advise.
Thanks and regards,
Phil Gott
Sent from my iPhone
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot
Unsubscribe/Manage:
http://autox.team.net/mailman/options/fot/tr4racing@googlemail.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot
Unsubscribe/Manage:
http://autox.team.net/mailman/options/fot/mharc@autox.team.net
|