Jack, my apologies if I misunderstood your last email. I thought you were
still trying to get the pinion & barrel off.
IIRC, on my starter, you have to push the "nut" towards the armature, and
pry out a clip that is normally trapped between it and a groove in the
shaft.
-- Randall
56 TR3 TS13571L once and future daily driver
71 Stag LE1473 - awaiting engine rebuild
71-2-3 Stag - awaiting gearbox rebuild
> Attached is a picture of a page from the workshop manual
> dealing with the TR-2/3 starter drive unit. I refer you to
> the section titled "Starter motor drive". I have completed
> items shown as number 1 and number 2. Item 3 talks about a
> "peg", which my starter does not have. In this case, it says
> to "Hold the squared end of the starter shaft and unscrew the
> locating nut F". However, holding the shaft, the locating
> nut just turns on the shaft, and nothing happens. Does
> anyone have any experience with disassembling this portion of
> the starter drive assembly? If so, I would appreciate any
> help you can give me to get this thing apart. Thanks.
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://autox.team.net/archive http://www.team.net/pipermail/fot
|