fot
[Top] [All Lists]

[Fot] Aftermarket Rod Question

Subject: [Fot] Aftermarket Rod Question
From: robertlangtr6 at yahoo.com (Robert Lang)
Date: Tue, 17 Apr 2018 15:23:55 +0000 (UTC)
References: <1147011712.1287179.1523978635590.ref@mail.yahoo.com>
Hi,
When installing aftermarket H-beam rods in a TR6 engine, is there an accepted 
measurement for the rod beam clearance to the bottom of the cylinder bore? I 
noticed that the stock TR6 block has a chamfer in the casting on one side but 
not on the other - it looks a little "tight" in there compared to the stock 
rods but that's expected due to the difference in the cross section of the H 
beam...
I'm just trying to verify if it's accepted practice to mill the pocket there on 
the side without the chamfer to make sure there's adequate clearance.
It's also a real beeeeyatch to actually see in there and even more of a pain to 
measure. Looks like a job for modelling clay, I would presume.
Feedback and suggestions are most appreciated.
Regards,Bob Lang339-927-4489
-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/fot/attachments/20180417/db7475c0/attachment.html>

<Prev in Thread] Current Thread [Next in Thread>
  • [Fot] Aftermarket Rod Question, Robert Lang <=