Use a three hooked gear puller / slide hammer to remove the hub.
David Nock
British Car Specialists
209-948-8767
www.britishcarspecialists.com
From: Corning, Dan (D.C.)
Sent: Wednesday, April 26, 2017 3:24 PM
To: healeys at autox.team.net
Subject: [Healeys] Replacing Hypoid Axle Grease Seal
I am trying to remove the rear axle hub and wheel bearing to replace the oil
seal located behind them. After removing the axle shaft, retaining nut and
lock washer, the photo shows the hub and bearing.
The inner race of the bearing seems to have an interference fit with the axle
housing. Can anyone tell me the proper method to remove the hub? Can I use
two long ? inch bolts in the threaded holes in the photo to ?push? the hub out
and then use an appropriate sized bearing driver to reinstall?
Best,
Dan Corning
--------------------------------------------------------------------------------
_______________________________________________
Archive: http://www.team.net/archive
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170426/d7f84f01/attachment.html>
|