fot
[Top] [All Lists]

[Healeys] Evans Waterless Coolant

Subject: [Healeys] Evans Waterless Coolant
From: coudesluijs at chello.nl (Oudesluys)
Date: Tue, 4 Apr 2017 13:29:34 +0200
References: <017a01d2ac14$a7988640$f6c992c0$@roadrunner.com> <C8182FEA3E3B4C558E3B9C8E86E7BA47@KagsLaptop>
Forget Evans, expensive and no real advantages except that it won't boil 
when the engine overheats although this allows you to enter the danger 
zone. Cooling efficiency is far less than cheap premix coolant which can 
be topped up with water in an emergency. And when the coolant boils, you 
know instantly the engine overheats!!
Be careful though with the modern non (less) toxic red coolant in older 
engines. It may cause havoc with seals and gaskets and should only be 
used in modern cars. Use the (slightly) more toxic blue or green variant 
which is safe for older classic engines.
You cannot cure cooling problem by using Evans. You will have to find 
the cause and rectify it.
Kees Oudesluijs


Op 4-4-2017 om 3:27 schreef Earl Kagna:
> Bruce:
> My experience with Evans coolant:  We decided to install it after the 
> engine was completely rebuilt in conjunction with a full restoration.  
> (BJ8).  We felt that it was an opportune time to do it was with a 
> completely dry cooling system..  So naturally what happened within the 
> first 200 miles ? a failed lower rad hose ? brand new, and a kevlar 
> one at that.  Not the coolant?s fault, but it illustrated an important 
> objection to the stuff ? the cost of replacing the amount that was 
> lost, approx. half, which I did.
> Ran it until a couple of months ago when we had to get into the engine 
> again to make some ?corrections?, so about 4 years total.  I decided 
> to go back to regular antifreeze / water coolant.  (I used the less 
> toxic polypropylene stuff).  The Evans has to be thoroughly cleaned 
> out of the system with a good proper flush when doing this.
> The engine ran fine with the Evans in it ? no overheating problems, no 
> bad smells, no difficulties.  The big advantage is that it simply 
> won?t boil, even if it gets very hot.  In my opinion, he best thing 
> that can be done for a big Healey cooling system is to use a more 
> efficient radiator core ? either re-core an original radiator, or get 
> a new aluminum radiator ? I?m told that the Wizard works very well by 
> people who know Healeys.
> My advice ? stay with regular coolant, the Evans simply isn?t worth it.
> Earl Kagna
> Victoria, B.C.
> BJ8, BT7 tri-carb
> *Sent:* Sunday, April 02, 2017 5:53 PM
> *Subject:* [Healeys] Evans Waterless Coolant
>
> Anyone using Evans Waterless Coolant?  If so, how is it working for you?
>
> Bruce Steele
>
> Brea, CA
>
> 1960 BN7
>
> ------------------------------------------------------------------------
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/healeys/kags at shaw.ca
>
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/coudesluijs 
> at chello.nl
>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/healeys/attachments/20170404/67993a3b/attachment.html>

<Prev in Thread] Current Thread [Next in Thread>