Metalize seal diameter and regrind to OEM dimension and install Christian
Marx' VITON SEAL.
Install vacuum system to crankcase, if you have not already.
Joe Alexander
A. R. E.
645 1st Street
Jesup, Iowa 50648
319.464.4711 (cell)
n197tr4@cs.com
-----Original Message-----
From: rkramer3 <rkramer3@austin.rr.com>
To: fot <fot@autox.team.net>
Sent: Mon, Jan 30, 2012 3:38 pm
Subject: [Fot] Oversize split seal for TR4 engine
I have had my share of machine shop disappointments over the years but this
one
hurt. I had two stock crankshafts cryo treated and reground with the intention
of building a lower rpm motor using Larry Young's camshafts and replacing the
crank in my son't TR4 racecar. At the time the machinist I had been using went
out of business and I tried a guy that had been recommended by a couple of
Spitfire guys in my local club. Long story short, he screwed up the grind on
the
scroll seal and overcut it. I put the crank in the TR4 and trimmed the seal a
little bit but the car leaks too much oil. Not very scientific, I know but I
was
desparate. Before I start experimenting has anyone found on oversize split
seal,
or split a seal on their own and could offer advice? I'd hate to throw two
cranks in the metal bin.
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/fot/n197tr4@cs.com
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|