Jim,
If I'm reading my cam spec sheet correctly, I'm running 254 degrees of
duration. Valve lash is currently .016" for exhaust and .015" for
intake. When I first installed the cam, it was recommended that I run
.022" exhaust and .020" for intake but the valve stem ends began to
show severe wear.
Hope this helps.
Allen
On Aug 24, 2007, at 3:30 PM, jim hearn wrote:
> It has been suggested to me that the valves on my '74 TR6 may need
> other
> than the stock settings since it has a hotter cam. I don't know what
> the
> cam is but it is definitely a hotter cam. I have only had the car a
> short
> time so my primary mission is to make sure there are no extraordinarily
> tight or loose valves. May be I could get a feel for the general
> settings
> and take any tight or loose ones to that settings.
>
> [demime 1.01d removed an attachment of type application/ms-tnef which
> had a name of winmail.dat]
> _______________________________________________
> http://www.team.net/donate.html
>
> awashatko@wi.rr.com
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
>
Jody & Allen Washatko
N65 W5567 Columbia Road
Cedarburg, WI. 53012
USA
tel. (262) 375-6888
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|