RE: 225hp

To:	<fot@autox.team.net>
Subject:	RE: 225hp
From:	"Randall Young" <ryoung@navcomtech.com>
Date:	Tue, 14 Jun 2005 16:36:03 -0700

> I was picturing a pin that slid inside the piston attached directly to the
> crank.

Problem is, then the piston would have to move sideways to follow the crank
throw.  Or were you thinking of a slot in the piston to accept the sideways
component, like the mechanism on a jig saw ?

Randall

<Prev in Thread]	Current Thread	[Next in Thread>
RE: 225hp, (continued) RE: 225hp, Jack W. Drews RE: 225hp, Bill Babcock RE: 225hp, Bill Babcock RE: 225hp, Bill Babcock Re: 225hp, Michael Porter RE: 225hp, Bill Babcock RE: 225hp, Bill Babcock Re: 225hp, jrhill RE: 225hp, Randall Young RE: 225hp, Bill Babcock RE: 225hp, Randall Young <= Re: 225hp, Larry Young Re: 225hp, michael cook RE: 225hp, Bill Babcock RE: 225hp, barry rosenberg Re: 225hp, Larry Young RE: 225hp, Bill Babcock Re: 225hp, Henry Frye Re: 225hp, Robert M. Lang Re: 225hp, N197TR4 Re: 225hp, triumph_marx

Previous by Date:	RE: rod length, Bill Babcock
Next by Date:	Address for "jonmac" at Heritage Motor Centre, JFrymark
Previous by Thread:	RE: 225hp, Bill Babcock
Next by Thread:	Re: 225hp, Larry Young
Indexes:	[Date] [Thread] [Top] [All Lists]