In a message dated 10/30/00 8:41:36 PM Pacific Standard Time,
jaboruch@netzero.net writes:
<< oe, I am using a 1 inch bar up front that someone had made about 30
years ago. It mounts in aluminum blocks that bolt to the front ends
of the frame. >>
Joe,
Speedway Engineering in California cut me a 1-1/4" hollow steel bar to my
specified length and put splines on the ends. They will also furnish either
aluminum or steel side arms for the bar. I used the aluminum, which seem to
be holding up, and cut them to the proper length using a hack saw. I
then drilled holes in the side arms, and used two 1/2" rod ends screwed and
locked together on each side. One rod end is bolted to the side arm, and the
other is bolted to a short piece of angle, which bolts to the front lower
control arm. Good luck.
|