On Wed, 16 Aug 2000, Joe Curry wrote:
> Anyone got a line on an effective but affordable rev limiter for my Spit
> Race Car project?
Well, you have a 4 cylinder motor with overhead valves, I'd say you have
8 little rev limiters... also known as valve springs.
;-)
If you want more than that, I'll go out on a limb and suggest that you'll
need some electronics. A lot of folks use the MSD 6AL or other
manufacturers' version of same (like the Crane Hi-6 and the various
offerings from Jacobs). If you shop around the hardware isn't that
expensive... figure a couple of "racer units" or US $200, maybe a bit more.
> Joe (C)
later,
rml
-------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent.
Consultant MIT Computer Services |
Voice: (617)253-7438 FAX: (617)258-9535 |
-------------------------------------------------------------------------------
|