I guess I might need to be more clear...
I want to determine if 2000 cam I have is actually the "B" grind I was
told it was when I bought the head. So I need to measure for lift and
duration (right?) to determine the grind of this cam.
Thanks!
On Wed, Dec 7, 2011 at 6:10 AM, Tim wrote:
> Can someone please send me a picture, drawing, diagram, hyrogliphic,
> .jpg, .gif, bitmap, etc that clearly shows where I need to put the
> micrometer in order to get an accurate measure of a cam shaft?
>
> A shot of a cam with the micrometer actually in/on the two spots
> needed to be measured would be greatly appreciated.
>
> Thanks very much!!!
>
> Tim
> ________________________________________
>
> datsun-roadsters@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/datsun-roadsters/tputland@charter.net
________________________________________
datsun-roadsters@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|