I knew a little sleep would do it - that, and all the pictures sent to me.
As I looked at the pictures it finally dawned on me.....over the
winter I took the wiper assembly apart to clean it up, and then put it
back together - wrong.
Thanks to all
-Bill
On 7/15/07, Gordon Glasgow <gsglasgow@comcast.net> wrote:
> It's hard to see clearly in this diagram, but look at the way the wiper
> motor mount is oriented. The lower, angled part of the mount clearly angles
> back towards the firewall of the car.
> http://www.gordon-glasgow.org/Images/24-2.gif
>
> Compare that with this picture and you can see that the mount is reversed.
> The raised portion at the base of the "tuning fork" stamping on the firewall
> is where the mount should attach.
> http://www.flickr.com/photos/datzun/809848881/in/set-72157600820597852/
>
> You can even see that the lip on the edges of the mount goes the other way.
> Take the thing out, remove the wiper arms, unbolt the three bolts that hold
> the motor to the mount, flip the mount over and reasssemble it.
>
> Gordon Glasgow
> Renton, WA
> www.gordon-glasgow.org
|
