The throwout bearing is pressed onto a rather large metal collar. In the
diagram at http://www.gordon-glasgow.org/Images/29.gif, the throwout bearing
is number 31 and the collar is 26-29. Number 32 is the wire spring that
holds the collar onto the clutch arm (number 13). Just pull on it, it'll
come out.
Unless you have a large press, I'd take it to a machine shop and have them
remove the old bearing and install the new one.
> -----Original Message-----
> From: owner-datsun-roadsters@Autox.Team.Net
> [mailto:owner-datsun-roadsters@Autox.Team.Net]On Behalf Of Ron Mistak
> Sent: Monday, October 11, 2004 2:56 PM
> To: datsun-roadsters@autox.team.net
> Subject: throwout bearing
>
>
> Hello to all
>
> This may be a dumb question but ,,, datsun 2000
>
> i have the transmission out of the 5 spd 2000, how do i install a new
> clutch throwout
> bearing on the small shaft its on , i have a new bearing but not sure how
> it comes off ..or if its
> all one piece
>
>
> thanks again
>
>
> Ron
>
> 67 1600
> 68 2000
> 69 2000
|
