Go to a plumbing store and get some 1/2" copper tubing and make a new one.
You may have to leave off the valve but you could always use sweat fittings
to make one very close to the original and reuse the valve if you plan
carefully.
BTDT
Mike
----- Original Message -----
From: "Vegas Mike" <datsun_sports@hotmail.com>
To: "Datsun Forum" <datsun-roadsters@autox.team.net>
Sent: Friday, September 13, 2002 3:39 PM
Subject: water pipe
> Hi,
>
> the water pipe ( the part that holds the heat shield) that I have needs to
be
> replaced. one part of the "Y" seems to have been cut off and the other
ends
> are rusted and flaking/cracking. does anyone have a good used one they
would
> like to sell?
>
>
> thx,
>
> mike
>
> /// datsun-roadsters@autox.team.net mailing list
> /// Send admin requests to majordomo@autox.team.net or go to
> /// http://www.team.net/cgi-bin/majorcool
> /// Archives at http://www.team.net/archive
> /// Send list postings to datsun-roadsters@autox.team.net
/// datsun-roadsters@autox.team.net mailing list
/// Archives at http://www.team.net/archive
|