datsun-roadsters
[Top] [All Lists]

Re: Mid-close gears and shifter throw

To: "Andrew Murphy" <solex67@hotmail.com>, <datsun-roadsters@autox.team.net>
Subject: Re: Mid-close gears and shifter throw
From: "Mike Kerr" <mikekerr@innercite.com>
Date: Thu, 27 Dec 2001 13:38:10 -0800
A mid close gear set works great with a solex setup, and a #2 solex cam,
you also need a lower rear end , a 4.37 or  better yet a 4.60....  this will
make it scream out of the hole, and your always are in the power band , and
don't have to bog the engine down....



Restoration Products
Mike Kerr
PH# 530-644-6777
Fax# 530-647- 0389
Web;  wolfgang@innercite.com


----- Original Message -----
From: "Andrew Murphy" <solex67@hotmail.com>
To: <datsun-roadsters@autox.team.net>
Sent: Thursday, December 20, 2001 7:37 PM
Subject: Mid-close gears and shifter throw


> Hey All,
>
> Last night I was watching Speedvision and the European touring car road
race
> championships were on. Lots of Audis, BMWs, and Mercedes chasing each
other
> around. I always notice the microscopic distance if the gear shift throw
on
> these cars. Obviously they are special race cars.
>
> Then I drive my 1500 around and it is an eternity between 2nd and third.
How
> much difference if any do mid-close and ultra-close boxes have on throw?
>
> Looking at getting a mid-close setup on my 67 2000. I seem to remember
> Victor Laury telling me he wasn't all that happy with his mid-close setup.
>
>
> Opinions? Info?
>
> Andrew Murphy
> 1964 1500
> 1967 2000 Solex
> SoCalROC
>
> _________________________________________________________________
> Join the worlds largest e-mail service with MSN Hotmail.
> http://www.hotmail.com
>
> ///  datsun-roadsters@autox.team.net mailing list
> ///  Send admin requests to majordomo@autox.team.net  or go to
> ///  http://www.team.net/cgi-bin/majorcool
> ///  Send list postings to datsun-roadsters@autox.team.net

///  datsun-roadsters@autox.team.net mailing list


<Prev in Thread] Current Thread [Next in Thread>