datsun-roadsters
[Top] [All Lists]

RE: happy, happy day

To: "Datsun Roadsters" <datsun-roadsters@autox.team.net>
Subject: RE: happy, happy day
From: "Gordon Glasgow" <gsglasgow@attbi.com>
Date: Sat, 15 Dec 2001 14:51:55 -0800
Hey, good on all of ya! I don't think I've ever seen two Datsun roadsters at an
autocross at the same time up here in the NW.

Gordon Glasgow
Renton, WA


> -----Original Message-----
> From: owner-datsun-roadsters@autox.team.net
> [mailto:owner-datsun-roadsters@autox.team.net]On Behalf Of Terry and
> Donna Cost
> Sent: Saturday, December 15, 2001 2:10 PM
> To: Datsun Roadsters
> Subject: happy, happy day
>
>
> Hello list,
>
> Just put up the Christmas stuff.  Can't put out the Santa Sleigh pulled by
> flamingos today because it's 50 degrees and driving rain, but will get that
> done later.  Otherwise I'm having a good day.
>
> To lower our roadsters Andy and I have used the old Sharp Competition manual
> recommendations.  We cut one coil from the front springs and made them flat
> on top, then added a 4"x4"x1" spacer between the rear axle and the spring
> plate.  Everything fits, the ride is not as harsh as store-bought
> competition springs, and the roadster looks and handles much better.  It's
> about an inch lower.  We also put real washers (not shims) between the
> a-arms and frame to give about 2-3 degrees negative camber in front.  I
> bought longer bolts for that.  I bought longer u-bolts for the rear spring
> mounts, also, and spent about $15 on all the lowering hardware, not counting
> the front springs somebody gave me.  I think a muffler shop's chop saw could
> make the tapered cut in the spring, but I used a 5" grinder and lots of
> patience.  The end of the new flat taper should be just under the end of the
> original flat taper.  Mark the taper before you cut.   Andy cut one coil too
> many the first time, and we had to scrap a set of springs.  The tires hit
> the tops of the fender wells big time.  If you'd like a set of super low,
> super stiff springs, have I got a deal for you!  Grind an inch off your
> brake calipers and run 13" rims.  On bumps you'll shower the admiring
> neighbors with sparks from frame rails, differentials, crossmembers, etc.
>
> Andy won the Equipe Rapide autocross trophy for CSP this year starting out
> in my 2000 and later campaigning his own "Tetanus" 2000.  Counting the best
> six finishes, he had two firsts and four seconds.  Pat and Mike Steinbach in
> a beautiful yellow 2000 together had two firsts, a second, and two fourths
> and I had a second and two thirds before I changed to a BMW and DSP.  Andy's
> chief competition other than Mike's 2000 was a very fast RX7, a Miata, and a
> BMW M3.   Since no one made all ten events, consistency counted a lot, and
> Andy finished high more than anyone else.  He's going to switch all his
> go-fast stuff to an EP roadster for next season.  We can still run my Grey
> Ghost if one of us breaks.
>
>
> Leisure Suit Terry
>
> ///  datsun-roadsters@autox.team.net mailing list
> ///  Send admin requests to majordomo@autox.team.net  or go to
> ///  http://www.team.net/cgi-bin/majorcool
> ///  Send list postings to datsun-roadsters@autox.team.net

///  datsun-roadsters@autox.team.net mailing list


<Prev in Thread] Current Thread [Next in Thread>
  • happy, happy day, Terry and Donna Cost
    • RE: happy, happy day, Gordon Glasgow <=