And the earlier RX-7 probably had the early 4x110mm bolt patten.
Thomas
the Swede
DemonTSi@aol.com wrote:
> In a message dated 09/16/2000 10:35:54 AM Pacific Daylight Time,
> spl310@hotmail.com writes:
>
> > By the way, has anyone got the dimensions for a Mazda rear end (from wheel
> > mounting pad to wheel mounting pad?)
>
> Yup, got one sitting in my backyard... width is about 57" total, +-1/4" (used
> an old measuring tape). Thing is, you will want the '84/85 GSL-SE rear end
> ONLY. Those were the only RX7 rears that came with the correct 4x114.3mm bolt
> pattern, and their axle shafts were thicker than the splined sections,
> allowing you to shorten them w/o any probs. The rest of the first-gen RX7
> rear ends had smaller diameter axles. The vented rear disk brakes on that
> particular rear is a nice added bonus.. :)
>
> \/ /\ /\/
> www.sr20parts.com
|