From: "Philip Erickson" <philip.erickson@Agouron.COM>
> I have installed the CDM front spoiler.
> I used fender beading between the spoiler and apron to give a more
> finished look. I used several 2" C clamps to hold it and marked the lip
> of the spoiler where it need to be trimed ~ 1/4 inch. I also marked
> where the seams of the fender and apron meet.. Next I laid out the
> holes for my screws evenly around the spoiler ( I most of used ~ 20 SS
> sheet metal screws, #4 I think from the local boat supply ). After
> drilling holes in the spoiler, I attached it with clamps again. I
> drilled pilot holes and installed the screws from the center out. I
> removed the spoiler and installed the beading.
> You could also just get some drill head sheet metal screws and go for
> it.
Hi gang-
Lurker Kyle here, a latecomer to this thread, as always;-) Anyone know
if this spoiler will fit a modified front end?
Here's what the PO did to my car:
http://www.sonic.net/~kyle/69f.jpg
(Yeah, I like it that way)
I have a CDM Spook on my 240Z, and can't say enough good things about it,
so it would likely be a good addition to my Toadster as well.
TIA
Kyle
Datsuns Galore
|
