After 2 years of assembly, cutting, welding etc. I am finally
putting the finishing touches on my 60 TR3 (Georgia licence
60 TR3A). Last night, when hooking the wires to the rear
turn lamps (single filament) the aged masking tape that I put
on to tell me their location was gone. I don't want to fry the
LBC after all this swork. The Bently manual schematic shows a
dual direction and tail lamp. Me thinks that this may be for a
pre #6000 com or a TR2.
Can one of you SOL'ers tell me the wire colors for the LH
hot and ground and RH hot and ground ? I believe that the
car has original wires.
Thanks in advance.
George DeVeau akguc.att.com!gfd
Norcross GA
|