Hi,
I just finished cleaning up the body mounting HW and was looking at the square
and trapezoidal body mounting pads and noticed that there are steel pads as
well as the rubber pads. Never encountered this on my previous 3 and 4
restorations.
Looking at the TRF parts book, they list the parts but mention they are used
as shims for door alignment.
Well as you might have guessed, I have no idea of how many pads go on each
side since I have 3 rectangular (front) pads and only 1 trapezoidal rear pad.
The pads were removed last fall and I can't remember which are which.
Will it be trial and error when I go to install the doors or is there some
assumption I can make based on the list's experience?
Don't know if it matters but this is a late 1972 TR6.
Thanks,
Bob
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|