6pack
[Top] [All Lists]

Re: [6pack] Toyota 5-speed seal failure?

To: triumphs@autox.team.net, 6 Pack list <6pack@autox.team.net>, Bill &
Subject: Re: [6pack] Toyota 5-speed seal failure?
From: Joe Merone <jmerone@rocketmail.com>
Date: Thu, 29 May 2008 07:02:34 -0700 (PDT)
Hey Bill:

Look at my message again.  No where in it do I say that I am actuallly having a 
problem with my seal.  And in fact I'm not.  I was referencing the discovery of 
a new potential problem, one of a few changes (solid driveshafts anyone?) that 
have contributed to my personal frustration and experience with the system.  
That's all.

So... when in doubt    RTFe-mail!

Joe Merone
CF18928 5-speed


--- On Wed, 5/28/08, Bill & AnnaBelle <anabil007@comcast.net> wrote:
 
If  you will read the  installation instructions from Herman you will  find ...

1. Extend the driveshaft to its maximum extension.
2. Install  the locking collar over the extension, right next to the 
driveshaft, so that it CANNOT RETRACT !!

8. If the driveshaft  dimension is longer than the distance from the 
distance from the transmission flange to the differential flange.  It 
MUST  BE SHORTENED by that amount.

So ... when in doubt   RTFIs ... <:-|

 

>I know that new engineered ideas evolve, things are discovered, 
>improvements are made, etc. but this is one reason (of a few) 
>that I now regret installing the Toyota 5-speed in my TR6 last 
>year.  Yes, regret. If I had to do it all over 
>again, I'd go with the OD instead 
>If you are considering the conversion you might want to re-think
it 
>Joe Merone
>CF18928
 


-- 
Bill  Pugh
1957 TR3 TS16765L
aka
Casper

AnnaBelle Pugh
1970 TR6 CC59179L
aka
Rosey
Wallace, CA
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack

http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>