RE: Rear Hub Conversions

[Chuck Arnold <chuck.arnold@oracle.com>]

I converted my rear axles to Nissan 280 Z's.  The cost, including custom 
inner bearing carriers created by Marty Sukey, was far less than $1300.  
Parts needed are 1978-80 280Z axles, and at least a special spicer 
ujoint that attaches the Nissan size carrier to the TR size inner half 
shaft.  I purchased new and beefier Spicer half shafts -- they were by 
far the most expensive part of the deal.

I can provide a parts list if the group wants it [have done so in the 
past to this list].

Chuck