Re: window crank

["David J Stauffacher" <dstauffa@csc.com>]

Alan,

Yes, thats right.  But to save yourself loads of aggravation, do this:

Get a 10p nail.
Take a hack saw and cut 2/3 the way through the nail at a point equal to
the the thickness of the window crank.
Push back on the panel and use a pliers to insert the nail through the
crank handle and arm.
Bend the nail back and forth to break it off.
Presto!
Handle is intalled.

David J. Stauffacher



                                                                                
                              
                      "Alan & Debbie                                            
                              
                      Lindner"                 To:      6pack@autox.team.net    
                              
                      <theedge                 cc:                              
                              
                      @cts.com>                Subject: window crank            
                              
                      Sent by:                                                  
                              
                      owner-6pack                                               
                              
                                                                                
                              
                                                                                
                              
                      02/07/2003 02:15                                          
                              
                      PM                                                        
                              
                      Please respond                                            
                              
                      to "Alan &                                                
                              
                      Debbie Lindner"                                           
                              
                                                                                
                              
                                                                                
                              




I want to be sure that I am doing this correct.

To install the window crank,
1. Put the spring under the door panel.
2. put the plastic washer on the outside of the door panel.
3. Push the crank on the shaft.
4. Try to put the pin into the crank and shaft hole.


=========================
Alan Lindner
'72 TR6 French Blue
CC75676L
San Diego, CA