I'm looking to add a 240V, 60 amp circuit for a ceramic kiln. My current panel is 200 amps with 20 spaces, and only has one slot open. Most likely I'll hire an electrician for this, but I'd like to
What is the brand of your existing panel? If it is a Square D, are the breakers in it marked QO1xx, or HOM1xx, where the xx is the current rating of the breaker. If it is a Square D QO panel, there
AFAIK, no. It's normal to have the branch circuits add up to more than the capacity of the main circuit. Of course the actual load has to remain below the main circuit capacity. If your kiln takes 6
Your subpanel doesn't have a breaker because there is a breaker in your main box that is used to supply the subpanel. It will be at a lower amp rating than your main box and the wires to the subpanel
There's probably a code restriction on the max, but nothing you've said makes me think that you're past it. I have a 60A subpanel in my garage, and there's a 50A circuit to run the (someday) TIG alo
Does your subpanel have a main breaker in it? If so, the wire would need to be at least big enough for that. Otherwise, I'd want wire big enough to handle any possible load you could configure in th
Nope, no breaker for the entire subpanel, in either the subpanel or the main box. Agreed. But since the subpanel is only a couple of inches away from the main panel, using "main line" gauge wire to