- 1. Re: [Overdrive installation] (score: 1)
- Author: Jan Eyerman <jan.eyerman@usa.net>
- Date: Fri, 15 Mar 2002 21:38:20 -0500
- Make yourself a set of 4 "alignment" studs. Just take off one of the tranmission to engine bolts and find a duplicate at least an inch longer. Buy 4 of them and cut the heads off. Then either file or
- /html/alpines/2002-03/msg00150.html (7,931 bytes)
- 2. Re: [Overdrive installation] (score: 1)
- Author: GSTROM99@aol.com
- Date: Sat, 16 Mar 2002 08:23:32 EST
- Wow, what a great idea!!! In the 30 or so years of playing with these toys, I've NEVER heard of that... Gary
- /html/alpines/2002-03/msg00151.html (6,857 bytes)
- 3. Re: [Overdrive installation] (score: 1)
- Author: "Tim Stiffy" <tstiffy@pulsenet.com>
- Date: Sat, 16 Mar 2002 10:56:16 -0800
- To remove the transmission from the Alpine, do you need to tip the engine backward for clearance? I'm replacing my tranny next month. Buy where install holes on trans move time are longer! appreciate
- /html/alpines/2002-03/msg00155.html (8,630 bytes)
- 4. Re: [Overdrive installation] (score: 1)
- Author: "Louis & Laila" <bwana@c2i2.com>
- Date: Fri, 15 Mar 2002 08:16:48 -0700
- Yes, just so everyone can know. If you remove an overdrive trans, you must unbolt the front of the engine from the crossmember, slide the engine forward a few inches, lower the rear, and slide the OD
- /html/alpines/2002-03/msg00162.html (9,703 bytes)
- 5. Re: [Overdrive installation] (score: 1)
- Author: RootesRooter@aol.com
- Date: Sun, 17 Mar 2002 01:07:00 EST
- << Even if you don't have OD, you must lower the rear of the engine. Be sure and disconnect the exhaust pipe. Lou >> ....and the carb linkage, too. Also put a small block of wood between the oil fill
- /html/alpines/2002-03/msg00163.html (6,971 bytes)
This search system is powered by
Namazu