Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*TR3A\s+front\s+suspension\s+question\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*TR3A\s+front\s+suspension\s+question\s*$/: 6 ]

Total 6 documents matching your query.

1. TR3A Front Suspension Question (score: 1): Author: Unknown; Date: Tue, 29 Aug 2000 21:19:46 -0400; I am getting my parts together for the up and coming process of rebuilding my '59 TR3A from the frame up. I plan on starting with the front suspension so I was sorting out TRF's front suspension rebu; /html/triumphs/2000-08/msg01531.html (7,130 bytes)
2. RE: TR3A Front Suspension Question (score: 1): Author: Unknown; Date: Tue, 29 Aug 2000 18:52:11 -0700; I believe the trunnion shaft cuts/forms the grooves as you tighten down the nut. Randall 59 TR3A On Tuesday, August 29, 2000 6:20 PM, suhring [SMTP:suhring@lancnews.infi.net] wrote:; /html/triumphs/2000-08/msg01534.html (7,580 bytes)
3. RE: TR3A Front Suspension Question (score: 1): Author: Unknown; Date: Wed, 30 Aug 2000 13:51:53 -0400charset="iso-8859-1"; Randal is correct. The trunnion shaft does cut grooves in new washers. Be sure to tighten both sides equally as you pull the washers onto the serrated section. This will prevent the trunnion shaft f; /html/triumphs/2000-08/msg01569.html (8,277 bytes)
4. TR3A front suspension question (score: 1): Author: Unknown; Date: Thu, 25 Nov 1999 19:49:15 -0600charset="iso-8859-1"; I am re-doing the front suspension on my TR3A. The cast lower left rear a-arm was bent. I bought a used replacement. It was bent worse than the one I took off. The replacement for the replacement was; /html/triumphs/1999-11/msg01098.html (6,863 bytes)
5. Re: TR3A front suspension question (score: 1): Author: Unknown; Date: Sat, 27 Nov 1999 09:08:30 EST; Hi Paul, The cast arms you write about, are attached to the bottom side of the spring pan with 6 bolts and hold the inner and outer trunnions together. When driving aggressively over rough roads, all; /html/triumphs/1999-11/msg01147.html (6,917 bytes)
6. Re: TR3A front suspension question (score: 1): Author: Unknown; Date: Sat, 27 Nov 1999 14:34:36 -0800; Hey Paul, I just rebuild the front suspension on 1960 TR-3A TS 72747 LO. All four lower A-arms were bent and/or had the trunnion bushings gone and had worn into the casting. I bought 4 used replaceme; /html/triumphs/1999-11/msg01165.html (8,432 bytes)

Current List: 1 - 6
Page: [1]