Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[TR\]\s+Input\s+Needed\s+\-\s+Float\s+Height\s+Adjustment\s+Tool\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*\[TR\]\s+Input\s+Needed\s+\-\s+Float\s+Height\s+Adjustment\s+Tool\s*$/: 5 ]

Total 5 documents matching your query.

1. [TR] Input Needed - Float Height Adjustment Tool (score: 1): Author: "Bob Danielson" <75TR6@tr6.danielsonfamily.org>; Date: Tue, 19 Sep 2006 19:59:05 -0400; I need input from the list on a "tool" that Frank Fisher has machined for simplifying float height adjustment on ZS carbs. When I had to do mine the challenge was getting a consistently accurate meas; /html/triumphs/2006-09/msg00298.html (8,117 bytes)
2. [TR] Input Needed - Float Height Adjustment Tool (score: 1): Author: "Bob Danielson" <75TR6@tr6.danielsonfamily.org>; Date: Tue, 19 Sep 2006 20:33:50 -0400; This time with my signature attached so you'll know who it's from. I need input from the list on a "tool" that Frank Fisher has machined for simplifying float height adjustment on ZS carbs. When I ha; /html/triumphs/2006-09/msg00300.html (8,482 bytes)
3. RE: [TR] Input Needed - Float Height Adjustment Tool (score: 1): Author: "Scott Suhring" <suhringtr36@comcast.net>; Date: Tue, 19 Sep 2006 21:42:47 -0400; I would be interested in purchasing this tool as it is a PIA to get a good measurement on the floats. Scott Suhring Mechanicsburg, PA '70 TR6 '59 TR3 --Original Message-- From: owner-triumphs@autox.t; /html/triumphs/2006-09/msg00302.html (8,711 bytes)
4. RE: [TR] Input Needed - Float Height Adjustment Tool (score: 1): Author: "Mark Hooper" <mhooper@digiscreen.ca>; Date: Tue, 19 Sep 2006 21:54:42 -0400; Want one! Mark 1972 TR6 ________________________________ This time with my signature attached so you'll know who it's from. I need input from the list on a "tool" that Frank Fisher has machined for s; /html/triumphs/2006-09/msg00303.html (8,576 bytes)
5. [TR] Input Needed - Float Height Adjustment Tool (score: 1): Author: "Bill Brewer" <bbrewer@tvwireless.net>; Date: Thu, 21 Sep 2006 08:11:10 -0700; Hi Mark, I don't know if it is the same for a TR6 as a TR3, but for the TR3 I made one out of a bolt with an unthreaded shank. I think that the manual said use a 7/16ths drill bit to set the float cl; /html/triumphs/2006-09/msg00337.html (7,816 bytes)

Current List: 1 - 5
Page: [1]