I would be interested in purchasing this tool as it is a PIA to get a good
measurement on the floats.
Scott Suhring
Mechanicsburg, PA
'70 TR6
'59 TR3
-----Original Message-----
From: owner-triumphs@autox.team.net [mailto:owner-triumphs@autox.team.net]
On Behalf Of Bob Danielson
Sent: Tuesday, September 19, 2006 8:34 PM
To: triumphs@autox.team.net
Cc: FGFO1@aol.com
Subject: [TR] Input Needed - Float Height Adjustment Tool
This time with my signature attached so you'll know who it's from.
I need input from the list on a "tool" that Frank Fisher has machined for
simplifying float height adjustment on ZS carbs. When I had to do mine the
challenge was getting a consistently accurate measurement. I even asked a
carb rebuilder what he used and it was a paper template that comes with the
rebuild kits. So I sent Frank a drawing with measurements based on a
cardboard template I made and here's what he came up with
(http://tinyurl.com/nxq33) I'd appreciate any input or suggestions from the
List as Frank could produce them if there was sufficient interest...or just
do a small run and sell them on eBay! I think this will only work on ZS CDSE
and CD-2SE carbs. If anyone is currently rebuilding their carbs let me know.
Maybe you can be the first to try the prototype.
Input is welcome, encouraged and needed.
Thanks
Bob Danielson
1975 TR6
http://tr6.danielsonfamily.org
=== This list supported in part by The Vintage Triumph Register
=== http://www.vtr.org
|