Mail Archive Search: <+subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Rusty\s+Flywheel\s*$/>

Results:

References: [ +subject:/^(?:^\s*(re|sv|fwd|fw)[\[\]\d]*[:>-]+\s*)*Rusty\s+Flywheel\s*$/: 6 ]

Total 6 documents matching your query.

1. Rusty Flywheel (score: 1): Author: Tburke4@aol.com; Date: Mon, 25 Sep 2000 13:23:22 EDT; Hello Folks, After my engine was marooned at the local gas station all Summer (don't ask), I am finally getting it back together. I dug out the flywheel and it has a nasty layer of rust on the side t; /html/spitfires/2000-09/msg00882.html (7,105 bytes)
2. RE: Rusty Flywheel (score: 1): Author: "David A. Templeton" <davidt@opentext.com>; Date: Mon, 25 Sep 2000 13:40:12 -0400; When I replaced the clutch earlier this summer I replaced the flywheel for a much better condition one. It only had surface oxidation but because I was putting in a new clutch I was told to get it re; /html/spitfires/2000-09/msg00883.html (8,337 bytes)
3. Re: Rusty Flywheel (score: 1): Author: mark holbrook <rolling_rock_12@yahoo.com>; Date: Tue, 26 Sep 2000 07:53:23 -0700 (PDT); == -Mark Holbrook __________________________________________________ Send instant messages & get email alerts with Yahoo! Messenger. http://im.yahoo.com/; /html/spitfires/2000-09/msg00900.html (7,893 bytes)
4. Re: Rusty Flywheel (score: 1): Author: Tburke4@aol.com; Date: Tue, 26 Sep 2000 11:26:47 EDT; << I always thought that everytime you do a clutch job you should get the flywheel turned. Just like a brake job. There is no point putting new pads on a warped rotor. Mark >> True enough, but I woul; /html/spitfires/2000-09/msg00902.html (7,530 bytes)
5. RE: Rusty Flywheel (score: 1): Author: Craig Smith <CraigS@iewc.com>; Date: Tue, 26 Sep 2000 10:33:41 -0500; I have replaced over 30 LBC clutch's and only once done the same vehicle. I have lightly polished the contact area with lapping compound and NEVER had a problem with the surface. I did have a bad thr; /html/spitfires/2000-09/msg00903.html (8,171 bytes)
6. RE: Rusty Flywheel (score: 1): Author: "Bill Miller" <millerb@netusa1.net>; Date: Tue, 26 Sep 2000 20:38:00 -0500; I've successfully used a DA with very fine sandpaper to remove the "glaze" or light rust many times. Use it sparingly and evenly. This is only if the flywheel does not have any "surface stress cracks; /html/spitfires/2000-09/msg00922.html (7,010 bytes)

Current List: 1 - 6
Page: [1]