- 1. Re: Spit rear sag (score: 1)
- Author: Jerome Judge <Goodlift@Sprintmail.Com>
- Date: Sat, 11 Sep 1999 11:52:55 -0400
- Hi Tom: Regular shocks will have no effect on the ride height. I think Victoria British has new rear springs for around $100.00. My advise is to pick one of these up. The cost is not that much more t
- /html/spitfires/1999-09/msg00416.html (7,914 bytes)
- 2. Re: GT6+ Interior (score: 1)
- Author: Jerome Judge <Goodlift@Sprintmail.Com>
- Date: Tue, 14 Sep 1999 09:39:17 -0400
- Hi Roger: I have a 72 GT6 from new with the brown interior. The dash pads were black. The top of the door panels were black. Everything else is brown including all carpets. Actually I have been wanti
- /html/spitfires/1999-09/msg00479.html (7,104 bytes)
- 3. Re: 64 Spit Bonnet (score: 1)
- Author: Jerome Judge <Goodlift@Sprintmail.Com>
- Date: Tue, 14 Sep 1999 10:12:14 -0400
- Hi George: I have a 72 GT6 but the hood is about the same as yours. There is quite a bit of flex in my hood also. When I lift up from the drivers side it is less, and I cannot lift the hood from the
- /html/spitfires/1999-09/msg00481.html (8,452 bytes)
- 4. Re: Front-end project questions (score: 1)
- Author: Jerome Judge <Goodlift@Sprintmail.Com>
- Date: Thu, 16 Sep 1999 18:39:53 -0400
- Hi Victor: I purchased the spring compressor from VB some time ago and it worked fine. You just need to grab the second coil from the top and bottom then tighten the nuts until you can get the spring
- /html/spitfires/1999-09/msg00582.html (9,803 bytes)
- 5. Re: Welders (score: 1)
- Author: Jerome Judge <Goodlift@Sprintmail.Com>
- Date: Sat, 18 Sep 1999 18:24:11 -0400
- Hi Tom: About 6 years ago I bought a Lincoln SP-100 MIG welder. It works great. It runs about 100 amps. Plenty of power for stuff up to 1/4 inch but can be reduced to handle auto sheet metal with no
- /html/spitfires/1999-09/msg00657.html (7,467 bytes)
- 6. Re: New water pump - Setting bearing? (score: 1)
- Author: Jerome Judge <Goodlift@Sprintmail.Com>
- Date: Thu, 30 Sep 1999 19:01:56 -0400
- Hi Paul: I think in the old days there were special procedures before installing a water pump. Something about swelling the leather seals, etc. With the new man made seals used today you should be ab
- /html/spitfires/1999-09/msg01014.html (7,597 bytes)
This search system is powered by
Namazu