- 1. disc brake piston boots (score: 1)
- Author: "Richard Bittmann" <edmyed@harbornet.com>
- Date: Tue, 15 Mar 2005 11:41:44 -0800
- Hello List: I frustrated trying to get the boots over the pistons. Here's what procedure I'm following: 1 install rubber ring into the lower ring recess after coating it and the caliper fluid chamber
- /html/healeys/2005-03/msg00344.html (6,842 bytes)
- 2. disc brake piston boots (score: 1)
- Author: "davidwjones" <davidwjones@cox.net>
- Date: Tue, 15 Mar 2005 14:55:19 -0500
- I thought those were a pain too.... If I remember correctly, I attached the boot to the caliper first, then applied a very light film of lithium grease to the lip of the boot. ...Then slid the piston
- /html/healeys/2005-03/msg00345.html (7,598 bytes)
- 3. Re: disc brake piston boots (score: 1)
- Author: "John Snyder" <helyjohn@cablespeed.com>
- Date: Tue, 15 Mar 2005 18:59:25 -0800
- I agree w/ David, except I use a small diameter wire w/ a 90 degree bend in the end instead of a screwdriver. Just slip the bent end under the lip of the seal and pull it around. John Snyder
- /html/healeys/2005-03/msg00360.html (7,688 bytes)
This search system is powered by
Namazu