1965 DATSUN ROADSTER CONVERTIBLE.....parting out,san jose,ca (san jose parting out 1965 datsun roadster convertible parts car,many nice cond parts available doors $75ea or $100pr trunk lid $65 hood w
I posed the same question to Joe Curto and here's what he has to say: "Matt, I do not believe that they were machined as matched sets but I do think that they were matched up after machining and have
FYI Bay Area folks, The ZONC meet is this weekend in Danville. No pre reg required, registration starts at 8am. See the url list below for map etc etc... http://www.zonc.org/BH62604.html Matt
Over the last week the Roadster has developed a rather noticeable whining noise coming from the front driver side of the car. I'm getting the sinking feeling it may be the front wheel bearing. The wh
Not San Jose or Bay Area, 408, 650, 510, 707, 925.... Anybody check out this ad yet? I think it is San Jose area. A bit too far from Ohio! "DATSUN '67-69 Roadster collection, Various conditions & pri
Three observations: 1) Many of problems that Roadster owners suffer from are the result of what a PO (previous owner) did or didn't do. Since you are lucky enough to have had your car for 21 years a
"Whats the 411 on the caravan for the solvang 311 show...LOL" Bay Area Roadster folks, I'm flexible (as I'd really like to be driving down in a group consider my recent meddling under the hood)-but m
Picked up a daily driver from a good friend, it needs a little TLC but should be a good runner for my commute. 68 1600 stock, has been sitting for sometime (6 months) but has been started and ran fi
Just did this one!! It's an M6 thread; the head would be optional but I use a flathead phillips drive. Length is dependent on how you mount the rest. I mounted mine using a flat then a finishing stai
The M6 and 1/4-28 must have a very close TP and size. The M6 really felt right but it was a test fit and process of elimination. I wish I would of had the conical point though, it was a "blind" job a
I'm a lil south and east of your last SJ stop, if possible, can you all can do fly by stop at 101 Coyote Creek exit just south of San Jose? The exit is a straight off and straight on. I'll be waitin
What is the recommended engine start-up procedure after internal engine work? Everything is bolted up and ready to crank and I want to ensure I get proper lubrication to all parts of the engine. Als
LOL, Alright alright!! Would the admission of a few extras parts at the bottom of the box(that I can't find in the manual) get me an answer? Cause, if you can't find it in the manual, is it really a