- 261. Re: Rear Inner bracket bushing bolt reversal (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Sun, 11 Jun 2006 22:07:30 EDT
- I'm sure you've figured out that once the trailing arm is installed, the only way to remove the hinge bolts that goes through the trailing arms to remove the trailing arm by taking off the brackets I
- /html/6pack/2006-06/msg00067.html (7,666 bytes)
- 262. miata seats (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Sat, 8 Jul 2006 18:46:14 EDT
- I've been looking forward to replacing my worn out stock seats with seats from a Miata, and I finally found a nice pair at a reasonable price. I've tried everything I can think of to get the seats lo
- /html/6pack/2006-07/msg00100.html (7,197 bytes)
- 263. TRF summer party (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Sat, 5 Aug 2006 21:46:00 EDT
- Is anyone going? I've not heard much discussion this year. Anyway, I'm looking for a caravan to join in central Va. Any of you Ga. or NC. guys going? Joe Davis
- /html/6pack/2006-08/msg00043.html (6,406 bytes)
- 264. horn blowing fuses (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Thu, 10 Aug 2006 20:34:27 EDT
- Everytime I hit the horn, the fuse blows. The system has historically worked fine since installing two new horns from moss and a new relay. I feel the relay vibrating, and buzzing, but nothing whatso
- /html/6pack/2006-08/msg00064.html (6,925 bytes)
- 265. Re: horn blowing fuses (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Sun, 13 Aug 2006 17:30:14 EDT
- thanks to all who offered advice about my horn fuse blowing problem. It turns out that the right side horn had become lose on it's bracket. It was flopping around and shorting out against my metal ra
- /html/6pack/2006-08/msg00084.html (6,779 bytes)
- 266. sticking throw out bearing (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Sun, 27 Aug 2006 13:19:24 EDT
- I would like to grease the input shaft. I'm pretty sure that it needs it because my clutch pedal is getting sticky and notchy.In retrospect, I'm pretty sure I neglected to lube it up when putting the
- /html/6pack/2006-08/msg00173.html (6,843 bytes)
- 267. Re: sticking throw out bearing (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Tue, 29 Aug 2006 20:27:18 EDT
- Thanks Marty, This sounds encouraging. I might try lubing the snout this way. It sure can't hurt unless I get grease on the clutch itself. I'm not sure how much of the snout is actually visable. I su
- /html/6pack/2006-08/msg00199.html (8,257 bytes)
- 268. Re: Trials 06 (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Fri, 22 Sep 2006 07:21:13 EDT
- I'm looking for a caravan to TRials. Is anyone traveling Thursday up 77 through WVa? I'll be heading west from near Lynchburg Va very early Thursday, using 64 from Lexington Va to Beckley WVa where I
- /html/6pack/2006-09/msg00212.html (6,536 bytes)
- 269. steering column wobble (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Tue, 3 Oct 2006 19:27:06 EDT
- I need to install steering column bushings, etc.. TRF sells a kit. Can someone describe what's involved. I know I'll have to pull steering wheel, the speedo and the tach. What else can I expect? Is t
- /html/6pack/2006-10/msg00028.html (6,883 bytes)
- 270. Re: Video (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Wed, 18 Oct 2006 15:21:00 EDT
- How 'bout that vette getting shot up? What a hoot
- /html/6pack/2006-10/msg00138.html (6,268 bytes)
- 271. slow overdrive (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Tue, 31 Oct 2006 20:16:06 EST
- The A type Overdrive in my daily driver 71 TR6 is a little slow to engage today. It usually engages almost instantly. Sometimes I even feather the clutch slightly to avoid the jerk as it engages. Bes
- /html/6pack/2006-10/msg00225.html (6,552 bytes)
- 272. [6pack] bogging down under load (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Sun, 24 Jun 2007 09:02:57 EDT
- Just put 600 miles on the TR6 with a trip to the outer banks on NC. All was well until the last 100 miles or so. I noticed the engine would bog down under load over 3000 rpms with the throttle wide o
- /html/6pack/2007-06/msg00167.html (6,337 bytes)
- 273. Re: [6pack] bogging down under load (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Tue, 26 Jun 2007 23:08:40 EDT
- I changed my fuel filter hoping that this would cure my high rpm power loss. It didn't. I pulled plug #2, 4, 6, and they all look fine, although #4 and fine, the throttles open fully and each carb lo
- /html/6pack/2007-06/msg00195.html (7,897 bytes)
- 274. [6pack] do I need an oil cooler? (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Mon, 16 Jul 2007 14:17:12 -0400
- I've done a lot of long distance >90 degree driving in the TR6 this summer, and have noticed a decrease in oil pressure. My engine has 25,000 miles on it. I'm running 15W/50 synthetic oil with a spin
- /html/6pack/2007-07/msg00128.html (7,100 bytes)
- 275. [6pack] TR6 in Southport NC (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Sat, 4 Aug 2007 21:46:10 EDT
- Any of you 6-packers in Southport NC? My kids and I saw an early Jasmine TR6 while on vacation there last week. If you saw a family in a Va. Honda Odyssey frantically waving at you it was us. From th
- /html/6pack/2007-08/msg00029.html (6,450 bytes)
- 276. [6pack] Trials lodging (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Thu, 6 Sep 2007 20:16:38 EDT
- Has anyone explored alternative lodging for trials? The host facility looks great, but I'm by myself and can't justify the cost. Anyone looking to split the cost of a room? Joe Davis
- /html/6pack/2007-09/msg00054.html (6,038 bytes)
- 277. [6pack] Trials room (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Mon, 10 Sep 2007 15:20:33 -0400
- Does anyone want to split a room at Hershey? I can't afford a room by myself...I'll sleep on the floor! Joe Davis
- /html/6pack/2007-09/msg00098.html (6,203 bytes)
- 278. [6pack] Trials Caravan (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Mon, 17 Sep 2007 09:36:25 -0400
- Anyone caravaning through central Virginia on Thursday? I'll be driving up US 15. I prefer to avoid 95 and DC traffic Joe
- /html/6pack/2007-09/msg00153.html (6,286 bytes)
- 279. Re: [6pack] Miata seat bracket (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Wed, 23 Apr 2008 20:57:47 EDT
- Has anyone figured out how to mount the Miata seats so that they are the same height as the TR seats? I've got a pair, but haven't installed because initial fitting showed that I would be looikng at
- /html/6pack/2008-04/msg00239.html (7,444 bytes)
- 280. Re: [6pack] Miata seat bracket (score: 1)
- Author: Lizirbydavis@cs.com
- Date: Thu, 24 Apr 2008 17:14:31 -0400
- _______________________________________________ Support Team.Net http://www.team.net/donate.html 6pack@autox.team.net http://autox.team.net/mailman/listinfo/6pack http://www.team.net/archive
- /html/6pack/2008-04/msg00244.html (9,786 bytes)
This search system is powered by
Namazu