0.005 thust washers used on both sides will take 0.010 out of the end
float. I've used 0.005 on one side and 0.000 on the other side.
Regards, Tony Drews
On 12/4/2020 3:13 PM, Bob Nogueira wrote:
> Catologs show that thrust washers are available in Standard and .005
> oversized.
> Since the washers act in both directions, front to back back to front, does a
> .005 set reduce total clearance .010?
> With standard size I currently have a bit more than .011 play. Will using a
> set of .005 washers, will the play be reduced to .006 or .001?
> Thank you
>
>
> Bob Nogueira
> ** triumphs@autox.team.net **
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/triumphs/tony@tonydrews.com
** triumphs@autox.team.net **
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/triumphs http://www.team.net/archive
Unsubscribe/Manage:
http://autox.team.net/mailman/options/triumphs/mharc@autox.team.net
|